Borrelli Open-Deck Display Fridge User Manual

Open-Deck Display Fridge · FDO-380C · FDO-1200C · FDO-1800C · Revision 1.0

This manual covers safe installation, day-to-day operation, cleaning and troubleshooting for the Borrelli Open-Deck Display Fridge. Please read it before operating the unit.

1. Warnings and Safety

These precautions ensure safe, correct use of the cold display and minimise the risk of injury or damage.

• Keep all ventilation vents clear while the unit is operating.
• Do not use mechanical devices to accelerate defrosting unless recommended by the manufacturer.
• Do not damage the refrigerant circuit.
• The LED lights must be replaced by a qualified person — contact the customer helpline.
• Do not use electrical appliances inside the food storage compartment.
• Do not damage, modify or excessively bend the power cord; if damaged, a qualified technician must replace it.
• Do not store explosive substances such as aerosol cans with flammable propellant in this appliance.
• Dispose of the unit only at an authorised waste centre; do not expose it to a flame.
• Disconnect the unit from power before cleaning, maintenance or replacing parts.
• All repairs, disassembly or modification must be performed by a qualified technician.
• Use a dedicated wall outlet; do not use flammable sprays or substances near the unit.
• The expected noise level of the unit is 55 dB.
• Do not insert anything (fingers, sticks, etc.) into the cold air suction outlet.
• Never place heavy objects or items containing water on top of the unit.
• After switching off, wait 5 minutes before restarting — restarting too soon can blow a fuse, trip the breaker or overload the compressor.

↑ Back to contents

2. Installation

Before use

• Remove all packaging and leave the door open to ventilate.
• Clean the unit before use.
• Run the unit empty for an hour before loading stock.

Placement and clearances

• Indoor use only; keep out of direct sunlight, rain and weather.
• Install on a flat, stable, level surface strong enough to support the unit when loaded.
• Allow a 100 mm gap on all sides and at the rear for airflow and ventilation.
• Site the unit away from doorways, fans and air-conditioning drafts.

↑ Back to contents

3. Cleaning

Exterior and interior

• For dust, wipe inside and out with a dry cloth.
• For a deeper clean, use a mild detergent and a soft cloth.
• Clean the unit regularly.
• Never use polishing powder, soap powder, benzine, oil or hot water — these damage the paint and plastic.

After cleaning, check the power cord for cracks or damage. If you find any, contact Borrelli.

↑ Back to contents

4. How to Use

Please note: this is a refrigerated cold display, not a household fridge.

Power switch

The illuminated red rocker switch turns the unit on and off – I for on, O for off. Allow a 5 minute interval before restarting the unit after powering it down.

Setting the temperature

We recommend a setting between 2 °C and 6 °C.

1. Press and hold the Set button for 2 seconds – the current set point is displayed.
2. Use the Up and Down arrows to adjust to your desired temperature.
3. Press Set again to return to the current temperature display.

Indicator lights

• Refrigerant LED (first snowflake): on while cooling; off once the set temperature is reached; flashes during a delayed start.
• Defrost LED (second snowflake): on during defrost; off when finished; flashes during a delayed defrost.
• °C / °F: shows the unit the temperature is displayed in.

Interior light and manual defrost

Press the Light button (lamp icon) once to turn the interior LEDs on; press it again to turn them off. Press and hold the Light button for 6 seconds to start a manual defrost. Holding it again pauses the cycle; otherwise it ends automatically. Defrost water drains to the tray, where it evaporates.

Loading the display

• Let the unit reach temperature before loading stock.
• Do not block the air vents or overfill the shelves.
• Keep all stock below the load line so the air curtain works correctly.

Controller reset

If the display shows “Disorder”: hold the Down arrow for 2 seconds until it beeps, then hold the Up arrow for 6 seconds until it beeps again. The display flashes for 3 seconds and restores factory settings.

↑ Back to contents

5. Tips and Tricks

Follow these tips to get the best performance, efficiency and lifespan from the cold display.

Transportation

• Never tilt the unit more than 45° during transport or moving.
• Allow it to stand for 12 hours before switching on, so the refrigerant can settle.
• Protect the power cord during transportation.

Drain tray

• Defrosting is automatic; drain water collects in the tray and evaporates automatically.

Shelves

• Adjust the shelves to suit the items on display.
• Each shelf has a maximum load of 18 kg.

Maintenance

• Have a qualified technician service the unit regularly.
• Clean the condenser and evaporator regularly (remove the rear panel to clear dust). Neglecting this shortens the lifespan and may void the warranty.

↑ Back to contents

6. Specifications

Figures from borrelli.com.au. FDO-1800C dimensions and weight are not published on the listing — confirm before print.

↑ Back to contents

7. Before Requesting Service

Please check the following if you encounter a problem. If it continues after these checks, contact Borrelli.

↑ Back to contents

8. Warranty and Enquiries

Warranty periods vary by product. For the period that applies to your model, see its product page. For the warranty terms and how to make a claim, see our Terms & Conditions. Keep your proof of purchase, as it may be required.

↑ Back to contents

Related manuals

Other Borrelli manuals:

• 1 Door Bar Fridge — BC-130
• 2 Door Bar Fridge — BC-210
• 3 Door Bar Fridge — BC-320
• 1 Door Upright Bar Fridge — BC-310U · BC-400H
• 2 Door Upright Bar Fridge — BC-510U · BC-800H · BC-1000H

See all Borrelli user manuals, or browse the related range.